Telnet Session; Host Telnet Port Number; Telnet Keepalive Messages - Neoware c50 - Thin Client User Manual

Resources & Command Line Options

Telnet Session

Initiate Telnet Session With Host
Resource:
Command Line: -tnhost hostname
Default Setting: Not applicable
These commands enable you to cause TeemTalk to initiate a telnet session with the
specified host.
Most emulations work quite well in the standard TeemTalk environment when the
telnet process provided with the workstation is used to make the connection to the
remote host. However, in some block mode emulations, especially the Tandem 6530
and IBM 3270, the telnet process does not pass all the necessary information to
TeemTalk.
To overcome this, TeemTalk has its own inbuilt telnet driver so that precise control
can be exercised over the information that TeemTalk receives and transmits. You must
use the telnet facility provided by TeemTalk when using block mode emulations such
as Tandem 6530 and IBM 3270.

Host Telnet Port Number

Resource:
Command Line: -tnport number
Default Setting: 23
These commands enable you to specify the number of your host's telnet port if it is
different from the default port number 23.

Telnet Keepalive Messages

Resource:
Command Line: -tnkeepalive
Default Setting: Enabled
These commands allow you to enable or disable telnet keepalive messages when
using the TeemTalk telnet driver.
25-16
xteemx340*tnHost: hostname
xteemx340*tnPort: number
xteemx340*tnKeepalive: on/off
enabled
+tnkeepalive disabled