Cursor Line Selection Extent; Bell Volume - Neoware c50 - Thin Client User Manual

Cursor Line Selection Extent

Resource: xteemx340*cutToBeginningOfLine: on/off
Command Line: -cb
+cb
Default Setting: Cursor to end of line.
These commands enable you to specify how much of the cursor line is selected when
the mouse button is clicked three times in quick succession. You can specify that the
entire cursor line is selected or only characters from the current cursor position to the
end of the line (default).
Keyboard Mapping
Resource: xteemx340*kbdType: keyboard type
Command Line: -kt keyboard type
Default Setting: Depends on the platform TeemTalk is running on.
These commands specify the type of keyboard being used and therefore how
TeemTalk maps functions to the keys. The valid settings are as follows:
pc for systems using the IBM PC AT 101/102 layout
e.g. Silicon Graphics and most X terminals.
vt for systems based on a true VT220 style layout
e.g. DECstation and VAXstation.
hp for traditional Hewlett Packard keyboards,
not the recent PC style.
sun4 for the Sun 4 keyboard layout.
sun5 for the Sun 5 keyboard layout.
Because there is no standard keyboard layout defined by X, and the codes generated
by the same key on different vendors' layouts are not always the same, the above
layouts may need some customisation in certain cases. Refer to the Keyboard
Operation chapter for details.

Bell Volume

Resource: xteemx340*bellVolume: 0-100
Command Line: -bv 0-100
Default Setting: Depends on the server
These commands enable you to specify the loudness of the bell (if the X server
supports this). The loudness is indicated by a numeric value in the range 0 (off) to
100 (full volume).
Resources & Command Line Options
cursor to end of line
entire cursor line
25-13