Configuring Trap Reporting - 3Com LANPLEX 6000 User Manual

Top-Level Menu
system
ethernet
display
fddi
mode
display
tokenring
community
addModify
bridge
trap
remove
ip
flush
snmp
smtProxyTraps
analyzer
script
logout
If the system is set for multiple agent mode, the traps configured for each
agent and the setting for proxying of remote SMT events is displayed.
Slot 1 - Chassis
Trap Destinations Configured
Address
158.101.112.3
Proxying of remote SMT events is disabled
Slot 2 - ESM
Trap Destination Agents Configured
Agent Trap Numbers Enabled
11-10, 12-21
Proxying of remote SMT events is disabled
Slot 3 - EFSM
No trap destination info configured
Proxying of remote SMT events is disabled
Configuring Trap Reporting
You can add new trap reporting destination configurations or you can
modify an existing configuration. You can define up to ten destination
addresses per agent and the set of traps that are sent to each destination
address or destination agent.
To add a new trap reporting destination configuration or modify a current
one:
1 From the top level of the Administration Console, enter:
snmp trap addModify
If the system is set for single agent SNMP mode, proceed to step 3. If the
system is set for multiple agent SNMP mode, you are prompted for either a
destination agent or a destination address.
2 Enter
dstAgents
3 Enter an IP address of the SNMP manager (destination address) or the
number of the destination agent(s) at the prompt.
4 Enter the trap number(s) you want to enable for that destination at the
prompt.
Separate a series of more than two trap numbers with a dash (-), and
non-sequential trap numbers by commas. Enter
all the traps for the destination.
Setting Up SNMP on Your System
Trap Numbers Enabled
1-10, 12-21
or at the prompt.
dstAddress
if you want to enable
all
3-25