Configuring The Display Of Non-Supported Mib Objects In The Ems Gui - 3Com 3CR15600 - Enterprise Management Suite Getting Started Manual

Configuring the
Display of
Non-supported MIB
Objects in the EMS
GUI

Configuring the Display of Non-supported MIB Objects in the EMS GUI

All MIB objects generated by an SNMP device that are not supported by
EMS are automatically hidden in the GUI client. However, if you prefer to
see non-supported MIB objects in the GUI as Not Supported, use this
procedure.
To configure the EMS GUI client to display non-supported MIB objects:
1 Using a standard text editor, open the client.properties file.
To locate the client.properties file, see
Management Suite Directories
2 Uncomment the showNoSuchName=yes line to enable the GUI client to
view non-supported MIB objects. See
Figure 39 Uncommenting the showNoSuchName Line
remove the pound sign
#showNoSuchName=yes
3 Save and close the client.properties file.
4 For these changes to take effect, stop and restart the EMS GUI client.
Navigating the Enterprise
on page 59.
.
Figure 39
131