Starting The Ems Cli Client; Stopping The Ems Cli Client; Using The Server Monitor To Monitor Ems Server Performance - 3Com 3CR15600 - Enterprise Management Suite Getting Started Manual

Starting the EMS CLI
Client
Stopping the EMS CLI
Client
Using the Server
Monitor to Monitor
EMS Server
Performance

Using the Server Monitor to Monitor EMS Server Performance

Figure 76 Stopping the EMS GUI Client
logout
and exit
To start the EMS Command Line Interface (CLI) client, see
Initial Setup on page
To access the CLI client console commands available, see
CLI Client Console Commands
To shut down the EMS CLI client, enter one of the following commands
from the EMS CLI command prompt:
■ exit
■ quit
■ stop
The EMS server monitor is a client-side program that connects to a
specific EMS server to monitor its key performance parameters. It charts
and optionally logs performance data such as transaction, trap, and
notification activity for the EMS server.
To start the EMS server monitor:
1 Open a command prompt window.
Make sure the EMS server is running before using this procedure.
2 Navigate to the directory containing the installed EMS software files, the
default through Windows is C:\Program Files\3Com\EMS.
3 From the command prompt, enter the following command and optional
parameters, as shown in
runServerMonitor [parameters]
55.
on page 204.
Table 47:
199
Installation and
Displaying EMS