Copying And Pasting Values Between Elements - 3Com 3CR15600 - Enterprise Management Suite Getting Started Manual

188 C 10: O
HAPTER PERATIONS
Copying and
Pasting Values
between Elements
4 Fill in the appropriate information the dialog box.
5 When finished, click OK.
A new row is added to the MIB table. You can change any of the editable
(simple) properties after adding the row, as described in
Properties on page
and index properties once adding the row to the table.
6 If you change any of the simple properties in the table, click Save all at
the bottom of the tab.
You can copy SNMP values from one element (for example, card or
server) to another. These elements must be exactly the same.
In the explorer tree, not all elements can values be copied. If this is the
case, you will receive a "No Related Elements Found" error message when
attempting to copy and paste values.
To copy SNMP values from one element to another:
1 In the explorer tree, select an element to copy values from.
2 On the main menu, select the Configuration menu and then select Copy
SNMP values.
Instead of using the Configuration menu, you can use the toolbar options
to copy and paste values.
3 Select another element of exactly the same type to paste values to.
4 On the main menu, select the Configuration menu and then select one of
the following options:
Paste SNMP values — pastes the SNMP values to the selected
■
elements only
Paste SNMP values to all — pastes the SNMP values to the selected
■
element and to any sub-elements that may be present.
185. However, you cannot change the informational
Editing Simple