Local_Server. Properties File - 3Com 3CR15600 - Enterprise Management Suite Getting Started Manual

90 C 4: S
HAPTER ERVER
local_server.
properties file
F C
AILOVER ONFIGURATION
The
local_server.properties
Server Failover, as shown below.
############## Remote Server For Server Failover #############
# This server identifies the remote server which forms part of
the Server Failover system.
# Remote_server=
############### Preferred Server For Server Failover
####################
# When Preferred_Server is set to 'yes', the EMS server starts
# its 'listener' system before trying to contact the remote EMS
# server specified by Remote_Server.
# Preferred_server=
############# Retry Count for Server Failover ################
# This specifies the number of attempts made to connect to the
remote server
# once the count reaches the Remote_Server_Retries value it
will make no further
# attempts
# Remote_Server_Retries=4
############# Timeout Count for Server Failover###############
# This specifies the number of seconds between any two retry
attempts
# when contacting the Remote_Server
# Remote_Server_Timeout=5
All Server Failover variables are commented out by default.
The local_server.properties file overrides the settings in
server.properties and is only ever read from the directory in
which the EMS server is running. To locate the files in
and override the
the following sequence:
1 EMS reads the
local_server.properties
setting which it then uses to locate
EMS_FILEHOME
2 Using
EMS_FILEHOME
3 EMS then re-reads
server.properties
While most of the contents of server.properties must be shared
between both servers, some settings, such as those for Server Failover,
file contains the settings for the EMS
server.properties
, EMS reads the
server.properties
local_server.properties
.
EMS_FILEHOME
settings, EMS reads the files in
file to obtain the
server.propertie
file.
to override any settings in
s.