3Com 3CR15600 - Enterprise Management Suite Getting Started Manual page 104

104 C 5: SNMP D
HAPTER
C
EVICE ONFIGURATION
Figure 23 Discovery Dialog Box for SNMP Devices
3 In the Discovery dialog box, enter the appropriate discovery parameters.
.
See Table 29
Table 29 Discovery Parameters
Parameter
Starting IP Address
Ending IP Address
IP Class Address Checking
Subnet Mask
Timeout (sec)
Retrys
SNMP Version
(continued)
Description
The first IP address in the range to be queried.
The last IP address in the range to be queried. Make
sure that the Ending IP Address is greater than or
equal to the Starting IP Address.
This parameter is used only during IP range discovery.
If you select this parameter (recommended), EMS will
automatically skip over network and broadcast
addresses based on the subnet mask.
NOTE: 3Com recommends making sure this option is
selected.
The subnet mask for this SNMP device.
The SNMP time out, in seconds. The default is 2.
The number of times EMS will retry connecting to an
SNMP device. The default is 2.
The SNMP version number.