Configuring Equipment Folder Parameters; Understanding The Discovery Interface - 3Com 3CR15600 - Enterprise Management Suite Getting Started Manual

118 C 5: SNMP D
HAPTER
Configuring
Equipment Folder
Parameters
Understanding the
Discovery Interface
C
EVICE ONFIGURATION
3 Type the new name for the selected element.
4 Click OK.
Every equipment folder created in EMS has a Discovery tab available to
view and configure parameters that pertain to that specific folder. You
can edit and re-run the discovery parameters from the equipment folder's
right-click menu to update the parameters that you want to associate
with the folder.
This section provides an overview of the various tabs and menus used for
the Discovery tab. The Discovery tab is configurable from the equipment
folder and is contains sixteen attributes. See
Table 36. If you configure these parameters at the equipment folder level,
they are applied to every device within this folder.
Figure 31 Discovery Tab
Table 36 Discovery Tab Attribute Descriptions
Attribute
Address Range (Begin)
Address Range (End)
Figure 31
Description
The first IP address in the range to be queried.
The last IP address in the range to be queried. Make
sure that the Ending IP Address is greater than or
equal to the Starting IP Address.
as described in