Using the Web Browser Interface for Advanced Configuration Tasks
Figure 16-68. Probe Configuration (ICMP Probe Type Shown)
5.
Click the Enable box to enable the probe.
6.
In the Probe Period field, specify the period for the probe, in seconds.
7.
In the Timeout field, specify the timeout for the probe, in milliseconds.
8.
Under Tolerance, use the Mode pull-down menu to specify the tolerance
for the probe:
•
Consecutive Failures—use the Number of Failures pull-down menu
to specify the number of consecutive test failures to allow before
declaring failure.
•
Failures per Set—use the Failure per Test and Test Size pull-down
menus to specify the number of failures allowed within a certain
number of tests before declaring failure.
9.
In the Destination hostname field, specify the IP address or hostname for
the destination that you want to monitor.
Setting Up Network Monitoring
16-85