Vpn Peer Name; Public Interface; Peer Type - HP 7102dl - ProCurve Secure Router Configuration Manual

Procurve secure router 7000dl series - advanced management and configuration guide

Hide thumbs Also See for 7102dl - ProCurve Secure Router:

Table of Contents

Using the Web Browser Interface for Advanced Configuration Tasks

Setting Up Virtual Private Networks

You must then choose between typical or custom setup. Custom setup is

exactly like typical setup except that it includes two extra windows in which

you can alter IKE and IPSec security parameters. Select the type of setup and

VPN Peer Name

You should enter the domain name for the device to which the local router

will connect. This name identifies the VPN peer, and, depending on how you

configure the peer's remote ID, IKE may use this name when authenticating

If you prefer, you can enter any alphanumeric name that identifies the con-

nection to you. You can also use the wizard to help build the initial VPN and

then modify the configuration in the CLI for more meaningful naming.

The wizard will first prompt you for the local router's public interface, or the

interface through which you connect to the VPN peer. Typically, this is the

WAN interface that connects to the Internet. Select this interface from the pull-

The pull-down menu only includes activated interfaces with an IP address.

Check the circle to indicate whether the peer is static, dynamic, or mobile.

Show Quick Links

Table of Contents