Redistributing Routes Into Ospf - HP 7102dl - ProCurve Secure Router Configuration Manual

N o t e
Using the Web Browser Interface for Advanced Configuration Tasks
If other routers in your WAN specify this network as a stub area, then you must
enter the area <area ID> stub OSPF configuration mode command in the
CLI. (See Chapter 15: IP Routing—Configuring RIP, OSPF, BGP, and PBR.)
Figure 16-116. Advertising an OSPF Network
c. Click Add.
d. Repeat steps a through c to add any other LAN networks on which
your router has an interface.
e. If you want your router to run OSPF between remote sites, you must
also add the networks for the router's WAN interfaces. Repeat steps
a through c.

Redistributing Routes into OSPF

Your ProCurve Secure Router's route table may include routes discovered in
several different ways. For example, you may have manually added a static
route to the table. A WAN interface may have discovered routes from an
external network that uses a different routing protocol, such as RIP. If you
want your router to include information about non-OSPF routes in its LSAs,
you must redistribute these routes into the router's OSPF database.
Any OSPF router that redistributes routes is defined an autonomous system
border router (ASBR). Typically, ASBRs are responsible for distributing exter-
nal routes throughout an OSPF network.
Routing
16-151