Using the Web Browser Interface for Advanced Configuration Tasks
Routing
16-152
Complete these steps to configure OSPF route redistribution:
1.
Select Routing under Router/Bridge in the navigation bar. In the Dynamic
Routing Protocols window, check the OSPF Configure button.
2.
The OSPF Configuration window displays.
Figure 16-117. Redistributing Routes into OSPF
3.
Typically, you must enable OSPF on a network in order for your router to
advertise that network. If your router connects to a network that does not
use OSPF, but that you want the router to advertise, you must redistribute
connected routes into OSPF. Check the Redistribute Connected box.
4.
If you want, check the Redistribute Static box to enable the router to
advertise routes manually added to its route table.
5.
Check the Redistribute RIP box to redistribute routes discovered by RIP
into the OSPF protocol.
6.
After you have selected the types of routes that you want to redistribute,
click Apply.
Generating a Default Route (ASBR)
An ASBR distributes external routes to routers in an OSPF network. Typically,
ASBR runs two routing protocols. For example, an ASBR that provides a
connection to the Internet could run BGP on its WAN interface and OSPF on
its LAN interfaces. A router that receives a default route from an external
network can also act as an ASBR.