Specifying Ospf Networks - HP 7102dl - ProCurve Secure Router Configuration Manual

Using the Web Browser Interface for Advanced Configuration Tasks
Routing
16-150
configure global OSPF parameters:
• the metric for redistributed routes
• global OSPF timers
• the reference bandwidth for computing connections' cost
configure parameters for individual OSPF interfaces:
• link cost
• OSPF timers
You must configure other OSPF options from the CLI.
In order to complete any OSPF configuration task, you will need to access the
OSPF windows. You can do so by completing these steps:
1. Select Routing under Router/Bridge in the navigation bar.
2. The Dynamic Routing Protocols window displays the routing protocols
supported by the ProCurve Secure Router. Click the Configure button for
OSPF.
When you are configuring advanced OSPF options, you can return to the main
OSPF windows, by selecting OSPF from the top navigation bar.

Specifying OSPF Networks

When you enable OSPF on a network, you enable:
router interfaces on that network to run OSPF (send hellos and LSAs)
all OSPF interfaces on the router to send LSAs for that network
When specifying a network, you must also place the network in an area.
Complete these steps to advertise and enable OSPF on a network:
1. Access the OSPF screen.
2. Move to the second window, Add a Network to be Advertised by OSPF.
Specify a network:
a. If your LAN uses OSPF, enter the network address and subnet mask
for the network on which your router has its Ethernet interface. Enter
these values in the IP Network and Subnet Mask fields. (See Figure
16-116.)
b. Specify the network's area. If your WAN does not use areas, enter 0.