Setting Lldp Operating Mode; Configuring Lldpdu Tlvs - 3Com 5500-EI PWR Install Manual

Hide thumbs Also See for 5500-EI PWR:
Table of Contents

Advertisement

To do...
Enable LLDP globally
Enter Ethernet interface view
Enable LLDP
To make LLDP take effect, you need to enable it both globally and on the related ports.

Setting LLDP Operating Mode

Follow these steps to set LLDP operating mode:
To do...
Enter system view
Set the initialization delay
period
Enter Ethernet interface view
Set the LLDP operating mode

Configuring LLDPDU TLVs

Follow these steps to configure LLDPDU TLVs:
To do...
Enter system view
Set the TTL multiplier
Enter Ethernet interface
view
Use the command...
lldp enable
interface interface-type
interface-number
lldp enable
Use the command...
system-view
lldp timer reinit-delay value
interface interface-type
interface-number
lldp admin-status { disable |
rx | tx | txrx }
Use the command...
system-view
lldp hold-multiplier value
interface interface-type
interface-number
1-5
Remarks
Required
By default, LLDP is disabled
globally.
Required
Optional, the configuration
applies to the current port only.
By default, LLDP is enabled on
a port.
Remarks
Optional
2 seconds by default.
Required
Optional, the configuration
applies to the current port only.
TxRx by default.
Remarks
Optional
4 by default.
Required

Advertisement

Table of Contents
loading

This manual is also suitable for:

5500-ei series

Table of Contents