Access Management Configuration Example; Access Management Configuration Examples - 3Com 5500-EI PWR Install Manual

Hide thumbs Also See for 5500-EI PWR:

Table of Contents

Access Management Configuration Example

Network requirements

Client PCs are connected to the external network through Switch A (an Ethernet switch).

The IP addresses of the PCs of Organization 1 are in the range 202.10.20.1/24 to

202.10.20.20/24. The IP address of PC 2 is 202.10.20.100/24, and that of PC 3 is

202.10.20.101/24.

Allow the PCs of Organization 1 to access the external network through Ethernet 1/0/1

on Switch A. The port belongs to VLAN 1, and the IP address of VLAN-interface 1 is

202.10.20.200/24.

Disable the PCs that are not of Organization 1 (PC 2 and PC 3) from accessing the

external network through Ethernet 1/0/1 of Switch A.

Network diagram

Figure 1-2 Network diagram for access management configuration

202.10.20.1/24～202.10.20.20/24

Organization1

Configuration procedure

Perform the following configuration on Switch A.

# Enable access management.

<Sysname> system-view

[Sysname] am enable

# Set the IP address of VLAN-interface 1 to 202.10.20.200/24.

[Sysname] interface Vlan-interface 1

[Sysname-Vlan-interface1] ip address 202.10.20.200 24

[Sysname-Vlan-interface1] quit

# Configure the access management IP address pool on Ethernet 1/0/1.

[Sysname] interface Ethernet 1/0/1

202.10.20.200/24

202.10.20.100/24 202.10.20.101/24

Table of Contents

5500-ei series