Jitter Test - 3Com 5500-EI PWR Install Manual

System busy operation number: 0
Operation sequence errors: 0
Other operation errors: 0
Http result:
DNS Resolve Time: 0
DNS Resolve Min Time: 0
DNS Resolve Max Time: 0
DNS Resolve Failed Times: 0
DNS Resolve Timeout Times: 0
TCP Connect Time: 73
TCP Connect Min Time: 5
TCP Connect Max Time: 20
TCP Connect Timeout Times: 0
[Sysname-remote-ping-administrator-http] display remote-ping history administrator http
remote-ping entry(admin administrator, tag http) history record:
Index Response
1
2
3
4
5
6
7
8
9
10
For detailed output description, see the corresponding command manual.
For an HTTP test, if configuring the destination address as the host name, you must configure the IP
address of the DNS server to resolve the host name into an IP address, which is the destination IP
address of this HTTP test.

Jitter Test

Network requirements
Both the remote-ping client and the remote-ping server are switches. Perform a remote-ping jitter test
between the two switches to test the delay jitter of the UDP packets exchanged between this end
(remote-ping client) and the specified destination end (remote-ping server).
Status LastRC
13 1
9 1
3 1
3 1
3 1
2 1
3 1
3 1
2 1
2 1
1-29
Connection fail number: 0
Drop operation number: 0
HTTP Operation Time: 675
HTTP Test Total Time: 748
HTTP Transmission Successful Times: 10
HTTP Transmission Failed Times: 0
HTTP Transmission Timeout Times: 0
HTTP Operation Min Time: 27
HTTP Operation Max Time: 80
Time
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4