MLD Snooping Interface Configuration
To access the MLD Snooping Interface Configuration page, click Switching
MLD Snooping
Interface Configuration.
Interface - Displays all physical, VLAN, and LAG interfaces. Select the interface you
1.
want to configure.
Use Admin Mode to select the interface mode for the selected interface for MLD Snooping
2.
for the switch. The default is disable.
Use Group Membership Interval(secs) to specify the amount of time you want the switch
3.
to wait for a report for a particular group on a particular interface before it deletes that
interface from the group. The valid range is from (2 to 3600) seconds. The configured value
must be greater than Max Response Time. The default is 260 seconds.
Use Max Response Time(secs) to specify the amount of time you want the switch to wait
4.
after sending a query on an interface because it did not receive a report for a particular
group on that interface. Enter a value greater or equal to 1 and less than the Group
Membership Interval in seconds. The default is 10 seconds. The configured value must be
less than the Group Membership Interval.
Web Management User Guide
141
Multicast