Snmp; Snmpv1/V2 - NETGEAR GSM7212P User Manual

Enter the Port in slot/port format and click Go. The entry corresponding to the specified
1.
Port, will be selected.
The following table describes the PoE PD Port Status non-configurable fields.
Field
Port
Mode
Class
Detection Mode
Status
Click REFRESH to refreshes the web page to show the latest PoE PD Port Status.
2.

SNMP

From SNMP link under the System tab, you can configure SNMP settings for SNMP V1/V2
and SNMPv3.
From the SNMP link, you can access the following pages:
on page 64
•

SNMPV1/V2

on page 70
• SNMP V3
SNMPV1/V2
The pages under the SNMPV1/V2 menu allow you to configure SNMP community
information, traps, and trap flags.
From the SNMP V1/V2 link, you can access the following pages:
• Community Configuration
• Trap Configuration
on page 68
• Trap Flags
• Supported MIBs
Web Management User Guide
on page 65
on page 66
on page 69
Description
The interface for which data is to be displayed.
The Mode is PD always.
The class of the Powered Device (PD) defines the
range of power a PD is drawing from the system.
Class definitions:
0 - 0.44-16.2(watts)
1 - 0.44-4.2(watts)
2 - 0.44-7.4(watts)
3 - 0.44-16.2(watts)
4 - 0.44-31.2(watts)
Power Device (PD) device class is always 4.
Displays the Power Device (PD) Detection Mode.
Displays the Power Device (PD) Powered Status.
64