Mac Binding Configuration - NETGEAR GSM7212P User Manual

Destination MAC Mask - Specifies the destination MAC address mask specifying
•
which bits in the destination MAC to compare against an Ethernet frame. Valid format
is (xx:xx:xx:xx:xx:xx). The BPDU keyword may be specified using a Destination MAC
mask of 00:00:00:ff:ff:ff. VLAN - Specifies the VLAN ID to compare against an
Ethernet frame. Valid range of values is 0 to 4095. Either VLAN Range or VLAN can
be configured.
Logging - When set to 'Enable', logging is enabled for this ACL rule (subject to
•
resource availability in the device). If the Access List Trap Flag is also enabled, this
will cause periodic traps to be generated indicating the number of times this rule was
'hit' during the current report interval. A fixed 5 minute report interval is used for the
entire system. A trap is not issued if the ACL rule hit count is zero for the current
interval. This field is only supported for a 'Deny' Action.
Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
3.
the latest value of the switch.
To delete a rule, select the check box associated with the rule and click DELETE.
4.
To change a rule, select the check box associated with the rule, change the desired fields
5.
and click APPLY. Configuration changes take effect immediately.

MAC Binding Configuration

When an ACL is bound to an interface, all the rules that have been defined are applied to the
selected interface. Use the MAC Binding Configuration page to assign MAC ACL lists to ACL
Priorities and Interfaces.
To display the MAC Binding Configuration page, click Security
Configuration.
Select an existing MAC ACL from the ACL ID menu. You can select one and bind it to
1.
the interfaces you wanted.
Web Management User Guide
292
 
ACL> Basic MAC Binding