NETGEAR GSM7212P User Manual page 331

To configure Port Mirroring:
Select the check box next to a port to configure it as a source port.
1.
Mode - Specifies the Mode for mirroring. By default Mode is disabled.
•
Use Source Port to specify the configured port(s) as mirrored port(s). Traffic of the
2.
configured port(s) is sent to the probe port.
In the Destination Port field, specify the port to which port traffic is be copied. Use the
3.
unit/slot/port format to specify the port. You can configure only one destination port on the
system. Acts as a probe port and will receive all the traffic from configured mirrored port(s).
Default value is blank.
From the Session Mode menu, select the mode for port mirroring on the selected port:
4.
Enable - Multiple Port Mirroring is active on the selected port.
•
Disable - Port mirroring is not active on the selected port, but the mirroring
•
information is retained.
Direction - Specifies the direction of the Traffic to be mirrored from the configured mirrored
5.
port(s). Default value is Tx and Rx.
Click APPLY to apply the settings to the system. If the port is configured as a source port,
6.
the Mirroring Port field value is Mirrored.
Web Management User Guide
331