Trap Flags - NETGEAR GSM7212P User Manual

Trap Flags

Use the Trap Flags page to enable or disable traps. When the condition identified by an
active trap is encountered by the switch, a trap message is sent to any enabled SNMP Trap
Receivers, and a message is written to the trap log.
To access the Trap Flags page, click System
To configure the trap flags:
Use Authentication to enable or disable activation of authentication failure traps by
1.
selecting the corresponding radio button. The factory default is enabled.
Use Link Up/Down to enable or disable activation of link status traps by selecting the
2.
corresponding radio button. The factory default is enabled.
Use Multiple Users to enable or disable activation of multiple user traps by selecting the
3.
corresponding radio button. The factory default is enabled. This trap is triggered when the
same user ID is logged into the switch more than once at the same time (either via telnet or
the serial port).
Use Spanning Tree to enable or disable activation of spanning tree traps by selecting the
4.
corresponding radio button. The factory default is enabled.
Use ACL to enable or disable activation of ACL traps by selecting the corresponding radio
5.
button. The factory default is disabled.
Use PoE to enable or disable activation of PoE traps by selecting the corresponding radio
6.
button. The factory default is enabled. Indicates whether PoE traps will be sent.
Click CANCEL to cancel the configuration on the screen. Resets the data on the screen to
7.
the latest value of the switch.
Click APPLY to send the updated configuration to the switch. Configuration changes take
8.
effect immediately.
Web Management User Guide

SNMP
68
 
SNMP V1/V2 Trap Flags.