Basic - NETGEAR GSM7212P User Manual

Basic

From the Basic link, you can access the following pages:
• 802.1X Configuration
802.1X Configuration
Use the 802.1X Configuration page to enable or disable port access control on the system.
To display the 802.1X Configuration page, click Security
802.1X Configuration.
To configure global 802.1X settings:
Select the appropriate radio button in the Port Based Authentication State field to
1.
enable or disable 802.1X administrative mode on the switch.
Enable. Port-based authentication is permitted on the switch.
•
If 802.1X is enabled, authentication is performed by a RADIUS
Note:
server. This means the primary authentication method must be
RADIUS. To set the method, go to Security > Management
Security > Authentication List and select RADIUS as method 1 for
defaultList. For more information, see "Authentication List
Configuration" on page 6-236.
Disable - The switch does not check for 802.1X authentication before allowing traffic
•
on any ports, even if the ports are configured to allow only authenticated users.
Default value.
Use VLAN Assignment Mode to select one of options for VLAN Assignment mode: enable
2.
and disable. The default value is disable.
Web Management User Guide
on page 254
254

Port Authentication
 
Basic