Mld Snooping Querier Configuration; Mld Snooping Querier Vlan Configuration - NETGEAR GSM7212P User Manual

Use Multicast Router to enable or disable the multicast router for the Vlan ID.
3.

MLD Snooping Querier Configuration

Use this menu to configure the parameters for MLD Snooping Querier. Note that only a user
with Read/Write access privileges may change the data on this screen.
To access the MLD Snooping Querier Configuration page, click Switching

Snooping Querier Configuration.
Use Querier Admin Mode to select the administrative mode for MLD Snooping for the
1.
switch. The default is disable.
Use Querier Address to specify the Snooping Querier Address to be used as source
2.
address in periodic MLD queries. This address is used when no address is configured on
the VLAN on which query is being sent. The supported IPv6 formats are x:x:x:x:x:x:x:x and
x::x.
Use MLD Version to specify the MLD protocol version used in periodic MLD queries. MLD
3.
queries.
Use Query Interval(secs) to specify the time interval in seconds between periodic queries
4.
sent by the snooping querier. The Query Interval must be a value in the range of 1 and
1800. The default value is 60.
Use Querier Expiry Interval(secs) to specify the time interval in seconds after which the
5.
last querier information is removed. The Querier Expiry Interval must be a value in the range
of 60 and 300. The default value is 60.
Field
VLAN Ids Enabled For MLD Snooping Querier

MLD Snooping Querier VLAN Configuration

To access the MLD Snooping Querier VLAN Configuration page, click Switching
 
MLD Snooping Querier VLAN Configuration.
Web Management User Guide
Description
Displays VLAN Ids enabled for MLD snooping
querier.
144
 
Multicast MLD

Multicast