NETGEAR GSM7212P User Manual page 111

Use Interface to select the physical interface for which data is to be displayed or
1.
configured.
Use Port GVRP Mode to choose the GARP VLAN Registration Protocol administrative
2.
mode for the port by selecting enable or disable from the dropdown list. If you select disable,
the protocol will not be active and the Join Time, Leave Time and Leave All Time will have
no effect. The factory default is disable.
Use Port GMRP Mode to choose the GARP Multicast Registration Protocol administrative
3.
mode for the port by selecting enable or disable from the dropdown list. If you select disable,
the protocol will not be active, and Join Time, Leave Time and Leave All Time have no
effect. The factory default is disable.
Use Join Time (centiseconds) to specify the time between the transmission of GARP
4.
PDUs registering (or re-registering) membership for a VLAN or multicast group in
centiseconds. Enter a number between 10 and 100 (0.1 to 1.0 seconds). The factory default
is 20 centiseconds (0.2 seconds). An instance of this timer exists for each GARP participant
for each port.
Use Leave Time (centiseconds) to specify the time to wait after receiving an unregister
5.
request for a VLAN or multicast group before deleting the associated entry, in centiseconds.
This allows time for another station to assert registration for the same attribute in order to
maintain uninterrupted service. Enter a number between 20 and 600 (0.2 to 6.0 seconds).
Web Management User Guide
111