Radius Server Configuration - NETGEAR GSM7212P User Manual

retransmit will not occur until the configured time-out value on that server has passed
without a response from the RADIUS server. Therefore, the maximum delay in receiving
a response from the RADIUS application equals the sum of (retransmit times time-out) for
all configured servers. If the RADIUS request was generated by a user login attempt, all
user interfaces will be blocked until the RADIUS application returns a response.
From the Accounting Mode menu, select whether the RADIUS accounting mode is
3.
enabled or disabled on the current server.
Use RADIUS Attribute 4 to enable or disable RADIUS attribute 4. Default value is Disable.
4.
This is an optional field and can be seen only when RADIUS attribute 4 is enabled. It
takes IP address value in the format (xx.xx.xx.xx).
Field
Current Server Address
Number of Configured Servers

RADIUS Server Configuration

Use the RADIUS Server Configuration page to view and configure various settings for the
current RADIUS server configured on the system.
To access the RADIUS Server Configuration page, click Security
Server Configuration link.

RADIUS
To configure a RADIUS server:
To add a RADIUS server, specify the settings the following list describes, and click ADD.
1.
In the Radius Server IP Address field, specify the IP address of the RADIUS server
•
to add.
In the Radius Server Name field, specify the Name of the server being added.
•
Use Port to specify the UDP port used by this server. The valid range is 0 - 65535.
•
Secret Configured - The Secret will only be applied if this option is "yes". If the option
•
is "no", anything entered in the Secret field will have no affect and will not be retained.
Web Management User Guide
Description
The Address of the current server. This field is blank
if no servers are configured.
The number of RADIUS servers that have been
configured. This value will be in the range of 0 and 3.
230

Management Security>