Basic - NETGEAR GSM7212P User Manual

ACL Based on Destination MAC - To create a ACL based on the destination MAC
•
address, destination MAC mask and VLAN.
ACL Based on Source MAC - To create a ACL based on the source MAC address,
•
source MAC mask and VLAN.
ACL Based on Destination IPv4 - To create a ACL based on the destination IPv4
•
address and IPv4 address mask.
ACL Based on Source IPv4 - To create a ACL based on the source IPv4 address
•
and IPv4 address mask.
ACL Based on Destination IPv6 - To create a ACL based on the destination IPv6
•
prefix and IPv6 prefix length.
ACL Based on Source IPv6 - To create a ACL based on the source IPv6 prefix and
•
IPv6 prefix length.
ACL Based on Destination IPv4 L4 Port - To create a ACL based on the destination
•
IPv4 layer4 port number.
ACL Based on Source IPv4 L4 Port - To create a ACL based on the source IPv4
•
layer4 port number.
ACL Based on Destination IPv6 L4 Port - To create a ACL based on the destination
•
IPv6 layer4 port number.
ACL Based on Source IPv6 L4 Port - To create a ACL based on the source IPv6
•
layer4 port number.
Use Rule ID to enter a whole number in the range of 1 to 1023 that will be used to identify
2.
the rule.
Use Action to specify what action should be taken if a packet matches the rule's criteria.
3.
The choices are permit or deny.
Use Destination MAC to specify the destination MAC address to compare against an
4.
Ethernet frame. Valid format is (xx:xx:xx:xx:xx:xx). The BPDU keyword may be specified
using a Destination MAC address of 01:80:C2:xx:xx:xx.
Use Destination MAC Mask to specify the destination MAC address mask specifying which
5.
bits in the destination MAC to compare against an Ethernet frame. Valid format is
(xx:xx:xx:xx:xx:xx). The BPDU keyword may be specified using a Destination MAC mask of
00:00:00:ff:ff:ff.
Click ADD to add a new rule to the ACL based on destination MAC.
6.
Click DELETE to remove the currently selected Rule from the ACL based on destination
7.
MAC.
Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
8.
the latest value of the switch.
Click APPLY to send the updated configuration to the switch. Configuration changes take
9.
effect immediately.

Basic

The Basic folder contains links to the following features:
on page 290
• MAC ACL
Web Management User Guide
289