NETGEAR GSM7212P User Manual page 235

range is 0–128 characters. The key must match the key configured on the TACACS+
server.
In the Connection Timeout field, specify the maximum number of seconds allowed to
2.
establish a TCP connection between the Managed Switch and the TACACS+ server.
Click CANCEL to cancel the configuration on the screen and reset the data on the screen to
3.
the latest value of the switch.
If you make any changes to the page, click APPLY to apply the new settings to the system.
4.
TACACS+ Server Configuration
Use the TACACS+ Server Configuration page to configure up to five TACACS+ servers with
which the switch can communicate.
To display the TACACS+ Server Configuration page, click Security

TACACS+ TACACS+ Server Configuration.
To configure TACACS+ server settings:
Use TACACS+ Server to enter the configured TACACS+ server IP address.
1.
Use Priority to specify the order in which the TACACS+ servers are used. It should be
2.
within the range 0-65535.
Use Port to specify the authentication port. It should be within the range 0-65535.
3.
Use Key String to specify the authentication and encryption key for TACACS+
4.
communications between the device and the TACACS+ server. The valid range is 0-128
characters. The key must match the encryption used on the TACACS+ server.
Use Connection Timeout to specify the amount of time that passes before the connection
5.
between the device and the TACACS+ server time out. The range is between 1-30.
Click ADD to add a new server to the switch. This button is only available to READWRITE
6.
users. These changes will not be retained across a power cycle unless a save is performed.
Click DELETE to delete the selected server from the configuration.
7.
Web Management User Guide
235

Management Security>