NETGEAR GSM7212P User Manual page 185

Use Proxy Arp to disable or enable proxy Arp for the specified interface from the pull-down
11.
menu.
Use Local Proxy Arp to disable or enable Local Proxy ARP for the specified interface from
12.
the pull-down menu.
Use Bandwidth to specify the configured bandwidth on this interface. This parameter
13.
communicates the speed of the interface to higher level protocols. OSPF uses bandwidth to
compute link cost. Valid range is (1 to 10000000).
Use ICMP Destination Unreachables to specify the Mode of Sending ICMP Destination
14.
Unreachables on this interface. If this is Disabled then this interface will not send ICMP
Destination Unreachables. By default Destination Unreachables mode is enable.
Use ICMP Redirects to enable/disable ICMP Redirects Mode. The router sends an ICMP
15.
Redirect on an interface only if Redirects are enabled both globally and on the interface. By
default ICMP Redirects Mode is enable.
Use IP MTU to specify the maximum size of IP packets sent on an interface. Valid range is
16.
68 bytes to the link MTU. Default value is 0. A value of 0 indicates that the IP MTU is
unconfigured. When the IP MTU is unconfigured the router uses the link MTU as the IP
MTU. The link MTU is the maximum frame size minus the length of the layer 2 header.
Field
VLAN ID
Link State
OSPF Admin Mode
Click DELETE to delete the IP Address from the selected interface.
Click REFRESH to refresh the web page to show the latest IP information.
Web Management User Guide
Description
Displays the VLAN ID for the interface.
The state of the specified interface is either Active or
Inactive. An interface is considered active if it the link
is up and it is in forwarding state.
Displays OSPF admin mode of the interface. The
default value is disable.
185