Mst Port Status - NETGEAR GSM7212P User Manual

MST Port Status

Use the Spanning Tree MST Port Status page to configure and display Multiple Spanning
Tree (MST) settings on a specific port on the switch.
To display the Spanning Tree MST Port Status page, click Switching
MST Port Status.
If no MST instances have been configured on the switch, the page
Note:
displays a "No MSTs Available" message and does not display the
fields shown in the field description table that follows.
To configure MST port settings:
Use MST ID to select one MST instance from existing MST instances.
1.
Use Interface to select one of the physical or port channel interfaces associated with VLANs
2.
associated with the selected MST instance.
Use Port Priority to specify the priority for a particular port within the selected MST
3.
instance. The port priority is set in multiples of 16. For example if the priority is attempted to
be set to any value between 0 and 15, it will be set to 0. If it is tried to be set to any value
between 16 and (2*16-1) it will be set to 16 and so on.
Use Port Path Cost to set the Path Cost to a new value for the specified port in the selected
4.
MST instance. It takes a value in the range of 1 to 200000000.
The following table describes the read-only MST port configuration information displayed on
the Spanning Tree CST Configuration page.
Field
Auto Calculated Port Path Cost
Port ID
Port Uptime Since Last Clear Counters
Web Management User Guide
Description
Displays whether the path cost is automatically
calculated (Enabled) or not (Disabled). Path cost will
be calculated based on the link speed of the port if
the configured value for Port Path Cost is zero.
The port identifier for the specified port within the
selected MST instance. It is made up from the port
priority and the interface number of the port.
Time since the counters were last cleared, displayed
in Days, Hours, Minutes, and Seconds.
124
  
STP Advanced