Installing And Removing Memory; Installing Dimms - Intel SR1530CL - Server System - 0 MB RAM User Manual

5. Install the server system cover. For instructions, see
Cover" on page

Installing and Removing Memory

Caution: The memory is NOT hot swappable. Before removing or replacing any memory DIMM,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
The silkscreen on the board for the DIMMs displays DIMM A1, DIMM A2, DIMM A3,
DIMM B1, DIMM B2, and DIMM B3 starting from the center of the board. See
"Memory" on page 15
"Server System References" on page ix

Installing DIMMs

To install DIMMs, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Locate the DIMM sockets. See
Server System User Guide
30.
for a discussion of the memory requirements and options. See
for a link to the list of tested DIMMs.
iii.
28.
Figure 28.
"Installing the Server System
"Removing the Server
"Safety
35