Removing Dimms; Installing Or Replacing The Processor; Installing The Processor - Intel SR1530CL - Server System - 0 MB RAM User Manual

Removing DIMMs

To remove a DIMM, follow these steps:
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Locate the DIMM sockets. See
5. Gently spread the retaining clips at each end of the socket. The DIMM lifts from
the socket.
6. Holding the DIMM by the edges, lift it from the socket, and store it in an anti-static
package.
7. Install the server system cover. For instructions, see
Cover" on page

Installing or Replacing the Processor

Caution: Processor must be appropriate: You may damage the server board if you install a
processor that is inappropriate for your server. See
page ix
Caution: ESD and handling processors: Reduce the risk of electrostatic discharge (ESD) damage to
the processor by doing the following: (1) Touch the metal chassis before touching the
processor or server board. Keep part of your body in contact with the metal chassis to
dissipate the static charge while handling the processor. (2) Avoid moving around
unnecessarily.

Installing the Processor

To install a processor, follow these instructions:
1. Observe the safety and ESD precautions at the beginning of this book. See
Information" on page
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see
System Cover" on page
4. Locate the processor socket and raise the socket handle completely.
Server System User Guide
iii.
30.
for a link to the list of compatible processor(s).
iii.
28.
Figure 28.
"Server System References" on
28.
"Removing the Server
"Installing the Server System
"Removing the Server
"Safety
"Safety
37