Configuring Ospf (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Configuring ScreenOS Devices Guide
Related
Documentation

Configuring OSPF (NSM Procedure)

320
Multiple MD5 Authentication— To use MD5 keys for authentication, select this option,
and then configure the active MD5 key.
To use an existing MD5 key, select the key ID as the active MD5 key ID.
To add a new MD5 key, click the Add icon and configure a key ID for the new MD5
key.
NOTE: You must use the same MD5 key for the sending and receiving
OSPF routers.
Configuring Route Preferences on page 312
Dynamic Routing Configuration Overview on page 313
OSPF Protocol Configuration Overview on page 313
Global OSPF Settings Overview on page 315
To configure OSPF:
In the NSM navigation tree, select Device Manager > Devices. Double-click the device
1.
object to open the device configuration.
In the device navigation tree, select Network >Virtual Router to display the list of
2.
configured virtual routers. Double-click the virtual router in which you are configuring
an OSPF routing instance. The Virtual Router configuration screen appears.
In the virtual router navigation tree, select Dynamic Routing Protocol and enable
3.
Configured OSPF Instance check box. OSPF configuration options now appear in the
virtual router navigation tree under Dynamic Routing Protocol.
In the virtual router navigation tree, select OSPF > Parameters to display the
4.
Parameters screen. Select OSPF, and then click OK to close the Parameters screen.
To define a new non-backbone OSPF area:
5.
Select OSPF > Area. The Area configuration screen appears. In this screen, do the
1.
following:
Click the Add icon.
Enter ID in the Area ID box.
Select the interfaces that are to be included in this OSPF area.
Select the Type.
Click OK to close the Area configuration screen.
2.
Copyright © 2010, Juniper Networks, Inc.