Configuring Rip (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Configuring ScreenOS Devices Guide
Related
Documentation

Configuring RIP (NSM Procedure)

Related
Documentation
322
Interface settings, such as authentication, that are set on a per-interface basis for the
RIP protocol. When you configure a RIP parameter at the interface level, the parameter
setting affects the RIP operation only on the specific interface.
Additionally, you can set security-related RIP settings at either the VR level or on a
per-interface basis.
Route Types Overview on page 295
Virtual Router General Properties Overview on page 297
OSPF Protocol Configuration Overview on page 313
Global RIP Settings Overview on page 323
RIP Interface Parameters Overview on page 325
BGP Overview on page 327
To enable RIP on a security device, you must first create a RIP instance on a virtual router,
and then enable RIP on individual interfaces.
To create a RIP instance on a virtual router:
In the NSM navigation tree, select Device Manager > Devices. Double-click the device
1.
object to open the device configuration.
In the device navigation tree, select Network > Virtual Router and double-click the
2.
virtual router for which you want to configure RIP.
In the virtual router navigation tree, select Dynamic Routing Protocol and enable
3.
Configured RIP Instance check box. The RIP settings appear in the router navigation
tree.
Select RIP > Parameters, and then select Enable RIP check box. If desired, configure
4.
additional global and security settings, as detailed in "Global RIP Settings Overview"
on page 323.
Click OK to save your changes to the virtual router.
5.
To enable RIP on an interface:
In the device navigation tree, select Network > Interface and double-click the interface
1.
for which you want to configure RIP.
In the interface navigation tree, select Protocol and select the RIP tab.
2.
Select Enable RIP. If desired, configure additional interface and security settings, as
3.
detailed in "RIP Interface Parameters Overview" on page 325.
Click OK to save your changes to the interface.
4.
Configuring Route Preferences on page 312
Copyright © 2010, Juniper Networks, Inc.