Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual page 195

Table 39: Configuring SNMPv3 Features in ScreenOS Devices
Option
SNMPv3 > Basic tab
Local Engine ID
SNMPv3 > USM User tab
User Name
Auth Protocol
SNMPv3 > View tab
View Name
Oid
Mask
Type
SNMPv3 > Access Group tab
Group
Security Model
Security Level
Notify
Read
Copyright © 2010, Juniper Networks, Inc.
In the NSM navigation tree, select Device Manager > Devices. The Device Tree page
1.
appears.
Click the Device Tree tab, and then double-click the security device for which you
2.
want to configure SNMPv3 features.
In the Configuration page, select Report Settings > SNMPv3. The SNMPv3 page
3.
appears.
Add or modify the SNMPv3 features as described in Table 39 on page 171.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Description
Identifies an SNMP entity and a USM with the respective privilege and password.
Specifies the username of the USM.
Specifies an authentication type. Select a value from the drop-down list. When you
select either MD5 or SHA, you are prompted to enter an authentication password.
Specifies the view name of the model. Each view is tagged with an object identifier (OID)
and mask values.
Specifies the object identifier. The format to enter an OID: Begin with "." and separate
by ".". For example, .3.4.5.2
Specifies the mask values of the view model. You can enter a two-digit value only.
Specifies if you want to include or exclude an IP address entry from the address list of
the MIB tables.
Specifies the access group name.
Specifies the security model for the access group.
Specifies the security level for the access group.
Specifies the notification parameter for the access group.
Specifies the read access privilege for the access group.
Chapter 5: Administration
171