Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual page 62

Configuring screenos devices guide
Hide thumbs Also See for NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01:
Table of Contents

Advertisement

Configuring ScreenOS Devices Guide
38
Using MLFR and MLPPP Options on page 55
Setting Physical Link Attributes for Interfaces on page 55
Enabling Management Service Options for Interfaces on page 56
Setting DHCPv6 Overview on page 57
Example: Assigning TCP/IP Settings for Hosts Using DHCP (NSM Procedure) on page 58
Configuring Custom DHCP Options (NSM Procedure) on page 59
Using Interface Protocol on page 61
Using Interface Secondary IP on page 61
Enabling ScreenOS Devices for Interface Monitoring on page 61
Supporting Generic Routing Encapsulation Using Tunnel Interfaces on page 62
Interface Network Address Translation Methods on page 62
Interface Network Address Translation Using MIPs on page 62
Example: Configuring MIPs (NSM Procedure) on page 63
Interface Network Address Translation Using VIPs on page 65
Mapping Predefined and Custom Services in a VIP on page 65
Example: Configuring VIPs (NSM Procedure) on page 66
Interface Network Address Translation Using DIPs on page 67
Example: Enabling Multiple Hosts Using Port Address Translation (NSM
Procedure) on page 68
Example: Translating Source IP Addresses into a Different Subnet (NSM
Procedure) on page 69
Enabling Managed Devices Using Incoming DIP on page 73
Example: Configuring Interface-Based DIP (NSM Procedure) on page 74
Example: Configuring DIP Pools on the Untrust Interface (NSM Procedure) on page 75
Example: Configuring an Aggregate Interface (NSM Procedure) on page 77
Example: Configuring a Multilink Interface (NSM Procedure) on page 78
Example: Configuring a Loopback Interface (NSM Procedure) on page 79
Configuring Virtual Security Interfaces on page 80
Example: Configuring a Redundant Interface (NSM Procedure) on page 80
Example: Configuring a Subinterface (NSM Procedure) on page 84
Example: Configuring a WAN Interface (NSM Procedure) on page 86
Configuring a Tunnel Interface on page 87
ADSL Interface in ScreenOS Devices on page 88
ADSL, ADSL Interface, and ADSL Settings in ScreenOS Devices on page 89
Determining Physical Ports and Logical Interfaces and Zones Using ScreenOS Devices
Port Mode on page 91
Backup Connection Using the Untrusted Ethernet Port in ScreenOS Devices on page 92
Copyright © 2010, Juniper Networks, Inc.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents