Irdp Support Overview - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual
Configuring screenos devices guide
Hide thumbs
Also See for NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01:
- Manual (340 pages) ,
- Administration manual (1026 pages) ,
- Installation manual (244 pages)
Table of Contents
Advertisement
Configuring ScreenOS Devices Guide
Related
Documentation
IRDP Support Overview
348
To configure a multicast static route:
In the navigation tree, select Device Manager > Devices. Double-click the device object
1.
to open the device configuration.
In the device navigation tree, select Network >Virtual Router to display the list of
2.
configured virtual routers. Double-click the virtual router in which you are configuring
a static multicast routing entry. The Virtual Router configuration screen appears.
In the virtual router navigation tree, select Multicast Routing Table. Configure the
3.
multicast routing preferences:
Select Enable Multiple Incoming Interfaces.
Select the Negative Mroute Cache. Leave the default Timer setting of 4096.
In the Multicast Static Routes area, click the Add icon. The New Mgroup dialog box
4.
appears. Configure the new routing entry:
For Multicast Group IP, enter 238.1.1.1.
For Source IP, enter 20.20.20.200.
For Incoming Interface, select ethernet1.
Configure an Outgoing Information setting:
5.
Click the Add icon. The New Outgoing Information dialog box appears.
For outgoing interface, select ethernet3.
For Outgoing Group, enter the IP address 238.2.2.1.
Click OK to add the Outgoing Information setting to the static route settings. Repeat
6.
step 5 to add more Outgoing Information settings.
Click OK to save your changes to the virtual router, and then click OK again to save
7.
your changes to the device.
Multicast Route Overview on page 337
Multicast Routing Table Entries Overview on page 346
Multicast Routing Table Preferences Overview on page 346
IRDP Support Overview on page 348
Configuring IGMP (NSM Procedure) on page 338
Configuring IGMP Proxy (NSM Procedure) on page 339
Configuring Multicast Static Routes on page 347
ICMP Router Discovery Protocol (IRDP) is an ICMP message exchange between a host
and a router. The security device is the router and advertises the IP address of a specified
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
