Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual page 55

Copyright © 2010, Juniper Networks, Inc.
Configure the Custom Policy Field:
3.
Enter a name for the field: enter ID.
Click the Required check box.
Select Integer from the Field Type list.
Enter a value in the Validation String box.
Enter any appropriate comments.
Click OK. A folder for the ID custom policy field object appears.
In the Objects tab, click on the ID folder. Click New. The New Custom Policy Fields
Data window appears.
Enter a value in the Data Value field: enter 1. Click OK. The new value appears in the
ID folder.
Repeat this step for all ten integer values.
In the Object Manager, create the Extranet Policy object with the appropriate rules.
To create an Extranet Policy object:
In the NSM navigation tree, click Object Manager > Extranet Policies. Then click Add
1.
Policy and the New ExtranetPolicyObject window appears.
Enter the name of the Extranet Policy: enter Extranet Policy1. Add a comment in the
2.
Comments field.
Configure the Extranet Policy object:
3.
Click Add Rule. The New - Rule window appears.
Specify an ID for the rule.
Add a comment for the rule.
Click Deny in the Action field.
Select a source address in the Source tab.
Select a destination address in the Destination tab.
Select services in the Service tab.
Select the integer IDs that you created in the Custom Policy Field object in the
Options tab.
Click OK.
4.
Create the router as an extranet device in the Device Manager. You will need to configure
the IP address of the device, any interfaces, and then bind the extranet policy to the
appropriate interface.
Chapter 2: Device Configuration
31