Example: Creating Device Level Vpn Type 3 (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Example: Creating Device Level VPN Type 3 (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
In this example, you create a RAS user group called Field Sales and configure an L2TP
tunnel called Sales_Corp, using ethernet3 (untrust zone) as the outgoing interface for
the L2TP tunnel. The security device applies the default L2TP tunnel settings to the RAS
user group.
NOTE: An L2TP-only configuration is insecure, and we only recommend it
for debugging.
The remote L2TP clients are on Windows 2000 operating systems. For information on
how to configure L2TP on the remote clients, refer to Windows 2000 documentation.
Only the configuration for the security device end of the L2TP tunnel is provided as in
Figure 2 on page 245.
Figure 2: PB RAS VPN, L2TP Example Overview
Configure the L2TP user objects. First, configure an L2TP user object for Adam, and
1.
then click OK:
For Name, enter Adam.
Select Enable, and then select L2TP.
Select Password, and then enter and confirm the password: AJbioJ15.
Configure an L2TP user object for Betty, and then click OK:
2.
For Name, enter Betty.
Select Enable, and then select L2TP.
Select Password, and then enter and confirm the password: BviPsoJ1.
Configure an L2TP user object for Carol, and then click OK:
3.
For Name, enter Carol.
Select Enable, and then select L2TP.
Chapter 8: Configuring VPNs
245