Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual page 96

Configuring ScreenOS Devices Guide
72
Enable the Multiple DIP Range check box.
Click the Add icon to display the New MultiRange of DIP dialog box.
For Rang ID, enter 1.
For Lower IP, enter 10.10.1.2.
For Upper IP, enter 10.10.1.2.
For Start, enter 210.10.1.1.
26.
For End, enter 210.10.1.1.
27.
For Shift From, enter 10.10.1.2.
28.
For Scale-Size, enter 1.
29.
Enable the Fixed Port check box.
30.
NOTE: The Fixed Port is enabled by default while adding multiple DIP
range for a DIP ID.
For Extended IP, enter 211.10.1.10.
31.
For Netmask, enter 24.
32.
Add the route to the Corporate Office on the trust-vr of Office B:
33.
In the device navigation tree, select Network > Routing. Double-click trust-vr router.
The General Properties screen appears.
In the trust-vr navigation tree, select Routing Table. Click the Add icon and configure
34.
the new route:
Set the IP address/netmask to 0.0.0.0/0.
For Next Hop, select Gateway, and the gateway options appear.
For Interface, select ethernet3.
For Gateway IP Address, enter 201.1.1.254.
Leave all other defaults, and then click OK to save the route.
Click OK to save your changes to the trust-vr, then click OK to save your changes
and close the Office A device configuration.
Add the Address Object that represents HQ:
35.
In the main navigation tree, select Object Manager > Address Objects. Click the
Add icon and select Host. The New Host dialog box appears.
Configure the Host as detailed below, and then click OK:
36.
For Name, enter Central Office HQ.
Select IP, and then enter the IP Address 200.1.1.1.
Copyright © 2010, Juniper Networks, Inc.