Configuring Virtual Routers - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Configuring ScreenOS Devices Guide

Configuring Virtual Routers

294
Configuring OSPF (NSM Procedure) on page 320
RIP Overview on page 321
Configuring RIP (NSM Procedure) on page 322
Global RIP Settings Overview on page 323
RIP Interface Parameters Overview on page 325
BGP Overview on page 327
Route-Refresh Capabilities Overview on page 328
Configuring BGP Networks on page 329
Configuring Aggregate Addresses on page 329
Configuring Neighbors and Peer Groups Overview on page 330
Configuring a BGP Routing Instance (NSM Procedure) on page 331
Configuring NHRP Overview on page 332
Configuring OSPFv3 Overview on page 333
Configuring RIPng Overview on page 336
Multicast Route Overview on page 337
Configuring IGMP (NSM Procedure) on page 338
Configuring IGMP Proxy (NSM Procedure) on page 339
Configuring PIM Sparse Mode (NSM Procedure) on page 341
Configuring a Rendezvous Point to Group Mappings (NSM Procedure) on page 342
Configuring Acceptable Groups (NSM Procedure) on page 343
Example: Configuring Proxy RP on page 345
Multicast Routing Table Entries Overview on page 346
Multicast Routing Table Preferences Overview on page 346
Configuring Multicast Static Routes on page 347
Example: Configuring Multicast Static Routes (NSM Procedure) on page 347
IRDP Support Overview on page 348
Example: Configuring ICMP Router Discovery Protocol (NSM Procedure) on page 349
Disabling IRDP on page 350
Policy-Based Routing Overview on page 351
Example: Configuring Policy-Based Routing (NSM Procedure) on page 352
To configure a virtual router, double-click the virtual router in the Virtual Router
configuration screen (or, either select the virtual router and then click the Edit icon, or
right-click the virtual router and select Edit). You can configure the following parameters
for a virtual router:
Copyright © 2010, Juniper Networks, Inc.