Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual page 196

Configuring ScreenOS Devices Guide
Table 39: Configuring SNMPv3 Features in ScreenOS Devices (continued)
Write
SNMPv3 > Community tab
Community Name
Tag
SNMPv3 > Sec-to-group Mapping tab
Group
Security Model
Mapping User
SNMPv3 > Filter tab
Filter Name
Oid
Mask
Type
SNMPv3 > Target Parameter tab
Target Parameter Name
Filter
Security Model
Security Level
Community
SNMPv3 > Target Address tab
Target Name
IPv4/IPv6 Address
Netmask/Prefix
Port
Target Parameter
172
Specifies the write access privilege for the access group.
Specifies the community name that is in combination with an access group.
Specifies the tag name. Each community is tagged.
Specifies the group name of the group section map.
Specifies the security model of the group section.
Specifies the username that is mapped with the USM.
Specifies the filter name. A security device can support up to 32 SNMPv3 filters.
Specifies the object identifier. The format to enter an OID: Begin with "." and separate
by ".". For example, .3.4.5.2
Specifies the mask values of the filter. You can enter a two-digit value only.
Specifies if you want to include or exclude an IP address entry from the address list of
the MIB tables.
Specifies the target parameter name that is used while sending a trap to a target. A
security device can support up to 32 target parameters.
Specifies the filter that you have created. Each filter is tagged to a target (host).
Specifies the security model of the target parameter.
Specifies the security level of the target parameter.
Specifies the community that you have created.
Specifies the target name.
Specifies either the IPv4 or IPv6 IP address. The system sends the trap to the target if
the mask is 32 for IPv4 addresses or 128 for IPv6 addresses.
Specifies the netmask of the IPv4 or IPv6 IP address.
Specifies the port.
Specifies the target parameter that you have created.
Copyright © 2010, Juniper Networks, Inc.