Redistribution Rules; Multicast Route Overview - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Table 84: Global RIPng Parameters and Default Values (continued)
RIPng Global Parameter
Maximum Number of Neighbors
Allowed on One Interface
Reject Default Route
Inbound Route Map
Outbound Route Map
Access List Number To Filter Only
Trusted Neighbors
Update Timer

Redistribution Rules

Related
Documentation

Multicast Route Overview

Copyright © 2010, Juniper Networks, Inc.
Description
Specifies the maximum number of RIPng neighbors allowed.
Specifies whether RIPng rejects a default route learned from
another protocol.
Specifies the filter for routes to be learned by RIPng.
Specifies the filter for routes to be advertised by RIPng.
Specifies an access list that defines RIPng neighbors. If no
neighbors are specified, the RIPng uses multicasting or
broadcasting to detect neighbors on an interface.
Specifies, in seconds, when to issue updates of RIPng routes
to neighbors.
Redistribution rules exchange route information between routing protocols. You need to
configure a route map to filter the routes that are redistributed. Routes imported into
RIPng from other protocols have a default metric of 10. You can change the default
metric.
You can redistribute the following types of rules into the RIPng routing instance in the
same VR:
Routes learned from BGP
Routes learned from OSPF
Directly connected routes
Imported routes
Statically configured routes
Configuring NHRP Overview on page 332
Configuring a BGP Routing Instance (NSM Procedure) on page 331
Multicast routing environments require the following items:
Chapter 10: Routing
Default Description
Value(s)
256
Disabled
None. Select a value from
the drop-down list.
None. Select a value from
the drop-down list.
None. All neighbors are
trusted.
30 seconds
337