Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual page 161

Copyright © 2010, Juniper Networks, Inc.
For Zone, select Trust (default setting).
For IP Address, enter 172.16.30.10.
For Netmask, enter 24.
Ensure that Manageable is enabled and that the Management IP is 172.16.30.10.
For Interface Mode, select NAT (default setting).
In the interface navigation tree, select DHCP. Set the DHCP mode to DHCP Server
4.
and configure as follows:
For DNS #1, DNS #2, and Client Gateway, enter 0.0.0.0.
For Lease Time, enter 60 (60 minutes).
Leave all other defaults.
Select the IP Pools tab, and then click the Add icon. the New DHCP IP Pool dialog
5.
box appears. Configure the following:
For IP Address, enter 172.16.30.2.
For Value, select End IP.
For End of Dynamic IP Range, enter 172.16.30.5.
Click OK to save the new IP Pool, and then click OK to save your changes to the
6.
interface.
Configure the ethernet3 interface (Untrust Interface):
7.
In the device navigation tree, select Network > PPPoE.
Click the Add icon. The New PPPoE Instance dialog box appears. Configure the
8.
following options:
For PPPoE Instance, enter eth3-pppoe.
For Interface, select ethernet3.
For username, enter user1.
For password, enter 123456.
For Concentrator-Name, enter ac-11.
Leave all other defaults.
Click OK to add the instance, and then click OK again to save your changes to the
9.
device.
Activate PPPoE and DHCP on the network.
10.
Turn off the power to the DSL modem, the security device, and any connected
11.
workstations.
Turn on the DSL modem.
12.
Chapter 4: Advanced Network Settings
137