Configuring Wi-Fi Protected Access (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SCREENOS DEVICES GUIDE REV 01 Manual

Configuring ScreenOS Devices Guide
Related
Documentation

Configuring Wi-Fi Protected Access (NSM Procedure)

402
encryption process, including the encryption type—Temporal Key Integrity Protocol (TKIP)
or Advanced Encryption Standard (AES)—and the rekey interval. For information about
TKIP, see the IEEE standard 802.11. For information about AES, see RFC 3268, Advanced
Encryption Standard (AES) Ciphersuites for Transport Layer Security (TLS).
You can also use WPA or WPA2 with a preshared key, which is a static key that is
configured on the security device and the client's device. Both devices use the key to
generate a unique key (group key) for the session. You can specify the preshared key by
using an ASCII passphrase (password) or in hexadecimal format. You also use the same
encryption types as with 802.1X authentication: TKIP or AES.
Wireless Settings in a Security Device Overview on page 381
Network, Interface, and Security Modules Supported in Security Devices on page 397
Chassis Information Overview on page 400
WPA2, Extended Range and SuperG Support on NetScreen5GT Wireless Overview on
page 401
Conducting a Site Survey for Detecting Access Points on page 397
To configure Wi-Fi protected access:
In the NSM navigation tree, select Device Manager > Devices.
1.
Select a security device and then double-click the device on which you want to define
2.
forced timeout. The device configuration appears.
In the device navigation tree, select Wireless.
3.
Configure the following wireless settings:
4.
For Select Specific Antenna, select Antenna diversity
For Channel for wireless AP radio, select Auto.
For Operation mode for AP, select 802.11b/g.
For Transmit Power, select Full.
For Data Rate for AP, select the best rate.
In the main navigation tree, select Wireless>SSID.
Select New and configure the following settings:
5.
For Name, enter my-ssid.
For Wireless Interface, select wireless 2.
For Authentication/Encryption, select WPA2.
For Select Encryption Method, select Auto.
Copyright © 2010, Juniper Networks, Inc.