Configuring Qos For An L2Tp Session; Figure 55: Lac Over Ethernet (With Lans) Scheduler Hierarchy; Figure 56: Lac Over Atm - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

Figure 55: LAC over Ethernet (With LANs) Scheduler Hierarchy

Figure 56: LAC over ATM

Related Topics

Configuring QoS for an L2TP Session

This section provides general procedures for configure QoS for an L2TP LNS session
or a LAC L2TP session.
For both procedures, the resulting scheduler hierarchy depends on the type of network
architecture that you use.
L2TP session interfaces have default QoS profiles and scheduler nodes. The default
configuration includes the following settings:
host1(config)# show qos-profile l2tp-session-default
t-class
Configuring QoS for an L2TP Session
interface rule
group type type
Chapter 22: Configuring QoS for L2TP Sessions
traffic scheduler queue
class profile profile profile
Configuring QoS for an L2TP Session
drop statistics
profile
199