Configuring Qos For An L2Tp Session; Figure 55: Lac Over Ethernet (With Lans) Scheduler Hierarchy; Figure 56: Lac Over Atm - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

Related
Documentation

Configuring QoS for an L2TP Session

Copyright © 2010, Juniper Networks, Inc.

Figure 55: LAC over Ethernet (With LANs) Scheduler Hierarchy

Figure 56: LAC over ATM

Configuring QoS for an L2TP Session
This section provides general procedures for configure QoS for an L2TP LNS session or
a LAC L2TP session.
For both procedures, the resulting scheduler hierarchy depends on the type of network
architecture that you use.
L2TP session interfaces have default QoS profiles and scheduler nodes. The default
configuration includes the following settings:
host1(config)# show qos-profile l2tp-session-default
t-class interface rule
group type type
Chapter 22: Configuring QoS for L2TP Sessions
traffic scheduler queue
class profile profile profile
drop statistics
profile
189