Chapter 29 Configuring Byte Adjustment For Shaping Rates With Qos Parameters; Byte Adjustment For Adsl And Vdsl Traffic Overview; Byte Adjustment For Cell Shaping Of Adsl Traffic Overview - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

For e series broadband services routers - quality of service configuration
Table of Contents

Advertisement

Chapter 29
Configuring Byte Adjustment for Shaping
Rates with QoS Parameters

Byte Adjustment for ADSL and VDSL Traffic Overview

Byte Adjustment for Cell Shaping of ADSL Traffic Overview

This chapter provides information for configuring byte adjustment with quality of
service (QoS) parameters on E Series routers.
QoS parameters are discussed in the following sections:
Byte Adjustment for ADSL and VDSL Traffic Overview on page 293
Guidelines for Configuring Byte Adjustment of Cell and Frame Shaping Rates
Using QoS Parameters on page 296
Configuring a Parameter Definition to Adjust Cell Shaping Rates for ADSL
Traffic on page 297
Configuring a Parameter Definition to Adjust Frame Shaping Rates for VDSL
Traffic on page 299
You can associate a parameter definition with a byte adjustment application to adjust
the shaping rates for ADSL and VDSL traffic on E Series Broadband Services Routers.
The byte adjustment differs for interfaces with cell shaping mode and frame shaping
mode. For ADSL traffic, JUNOSe software supports a byte adjustment application
(qos-byte-adjustment) to adjust rates for cell shaping mode. For VDSL traffic, JUNOSe
software supports a frame byte-adjustment application (qos-frame-byte-adjustment)
to adjust rates for frame shaping mode.
Frame is the default shaping mode for Ethernet interfaces on E Series routers. To
configure the cell shaping mode, issue the qos-shaping-mode command or by
specifying the qos-cell-mode application with a parameter definition.
Managing the bandwidth of downstream ATM traffic to Ethernet interfaces is difficult
because of the different layer 2 encapsulations. To reduce the number of packet
drops in the Ethernet network, you can use the byte adjustment applications to
account for the different encapsulations.
Byte Adjustment for ADSL and VDSL Traffic Overview
293

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.1.x

Table of Contents