Creating a Parameter Instance for an S-VLAN
Use this procedure to attach a parameter instance to a specified S-VLAN ID on the
interface. Optionally, use the qos-profile keyword to attach a parameter instance to
a QoS profile.
To create a parameter instance for an S-VLAN:
1.
2.
3.
Related Topics
Example: QoS Parameter Configuration for Controlling Subscriber Bandwidth
The example in this section illustrates how to use parameters to control the minimum
and maximum bandwidth of a subscriber. The example includes procedures for both
QoS administrators and QoS clients.
Attach the parameter instance and associate with the QoS profile.
host1(config-if)#atm-vp 4 qos-profile video qos-parameter
max-subscriber-bandwidth 375000
Specify the Ethernet interface and create the VLAN.
host1(config)#interface gigabitEthernet 3/0
host1(config-if)#encapsulation vlan
host1(config-if)#interface gigabitEthernet 3/0.1
Specify the S-VLAN ID.
host1(config-if)#svlan id 1 202
Attach the parameter instance to an S-VLAN ID on the interface.
host1(config-if)#svlan 202 qos-parameter max-subscriber-bandwidth 6000000
Parameter Instances for QoS Clients Overview on page 240
For information about creating QoS parameter instances for Service Manager,
see JUNOSe Broadband Access Configuration Guide
atm-vp qos-parameter
atm vp-tunnel
encapsulation vlan
interface
qos-parameter
svlan id
svlan qos-parameter
Chapter 25: Configuring a QoS Parameter
Creating a Parameter Instance for an S-VLAN
243