JUNOSe 11.1.x Quality of Service Configuration Guide
Configuring Default Integrated Mode for ATM Interface
In the default integrated mode, the SAR scheduler is the dominant scheduler, and it
backpressures the first-stage (HRR) scheduler per VC. Each VC buffers only a few
hundred bytes.
Figure 44 on page 168 shows the default integrated mode.
Figure 44: Default Integrated Mode
To configure default integrated mode:
1.
TIP: For ATM interfaces on ERX7xx models, ERX14xx models, and the ERX310
router, you must specify port 0.
168
Configuring Default Integrated Mode for ATM Interface
From the desired port, set the QoS port mode to default integrated mode.
host1(config)#interface atm 2/0
host1(config-if)#no qos-mode-port